DIN 472 circlip, 10 mm bore
Circlips › DIN 472-10
A DIN 472-10 is an internal circlip (a bore clip) for a 10 mm bore, 1 mm thick. Cut the groove Ø10.4 mm, 1.1 mm wide and 0.2 mm deep, and fit it with inside pliers, size J0.
| Bore Ø | 10 mm |
|---|---|
| Clip thickness | 1 mm |
| Groove Ø | 10.4 mm |
| Groove width | 1.1 mm |
| Groove depth | 0.2 mm |
| Pliers | inside, size J0 |
Sizes from DIN 472, as Benchsmith's Find → Circlip gives them. Groove depth = (bore Ø − groove Ø) ÷ 2.
Open DIN 472-10 in BenchsmithAdd to order list
Bench note · why the groove, not the clip
The clip is named by the bore it fits (Ø10), but you cut the groove: Ø10.4, 1.1 wide, 0.2 deep. Square corners at the bottom so the clip sits flat against the side.
Bench note · why inside pliers
A bore clip (DIN 472) is squeezed to go in: inside pliers. Squeeze it only as far as it takes; bent past that it springs out under load.
Same Ø, shaft clip
- DIN 471-10shaft Ø10, groove Ø9.6
One size up or down
- DIN 472-9bore Ø9 (down)
- DIN 472-11bore Ø11 (up)
Clip gone and only the groove left? Measure the bore, or the bottom of the old groove, and type it into Benchsmith → Find → Circlip.