DIN 471 circlip, 95 mm shaft
Circlips › DIN 471-95
A DIN 471-95 is an external circlip (a shaft clip) for a 95 mm shaft, 3 mm thick. Cut the groove Ø91.5 mm, 3.15 mm wide and 1.75 mm deep, and fit it with outside pliers, size A3.
| Shaft Ø | 95 mm |
|---|---|
| Clip thickness | 3 mm |
| Groove Ø | 91.5 mm |
| Groove width | 3.15 mm |
| Groove depth | 1.75 mm |
| Pliers | outside, size A3 |
Sizes from DIN 471, as Benchsmith's Find → Circlip gives them. Groove depth = (shaft Ø − groove Ø) ÷ 2.
Open DIN 471-95 in BenchsmithAdd to order list
Bench note · why the groove, not the clip
The clip is named by the shaft it fits (Ø95), but you cut the groove: Ø91.5, 3.15 wide, 1.75 deep. Square corners at the bottom so the clip sits flat against the side.
Bench note · why outside pliers
A shaft clip (DIN 471) is opened to go on: outside pliers. Open it only as far as it takes to pass the shaft; stretched too far it stays loose in the groove.
One size up or down
- DIN 471-90shaft Ø90 (down)
- DIN 471-100shaft Ø100 (up)
Clip gone and only the groove left? Measure the shaft, or the bottom of the old groove, and type it into Benchsmith → Find → Circlip.