DIN 471 circlip, 80 mm shaft
Circlips › DIN 471-80
A DIN 471-80 is an external circlip (a shaft clip) for a 80 mm shaft, 2.5 mm thick. Cut the groove Ø76.5 mm, 2.65 mm wide and 1.75 mm deep, and fit it with outside pliers, size A3.
| Shaft Ø | 80 mm |
|---|---|
| Clip thickness | 2.5 mm |
| Groove Ø | 76.5 mm |
| Groove width | 2.65 mm |
| Groove depth | 1.75 mm |
| Pliers | outside, size A3 |
Sizes from DIN 471, as Benchsmith's Find → Circlip gives them. Groove depth = (shaft Ø − groove Ø) ÷ 2.
Open DIN 471-80 in BenchsmithAdd to order list
Bench note · why the groove, not the clip
The clip is named by the shaft it fits (Ø80), but you cut the groove: Ø76.5, 2.65 wide, 1.75 deep. Square corners at the bottom so the clip sits flat against the side.
Bench note · why outside pliers
A shaft clip (DIN 471) is opened to go on: outside pliers. Open it only as far as it takes to pass the shaft; stretched too far it stays loose in the groove.
Same Ø, bore clip
- DIN 472-80bore Ø80, groove Ø83.5
One size up or down
- DIN 471-78shaft Ø78 (down)
- DIN 471-85shaft Ø85 (up)
Clip gone and only the groove left? Measure the shaft, or the bottom of the old groove, and type it into Benchsmith → Find → Circlip.