DIN 471 circlip, 48 mm shaft
Circlips › DIN 471-48
A DIN 471-48 is an external circlip (a shaft clip) for a 48 mm shaft, 1.75 mm thick. Cut the groove Ø45.5 mm, 1.85 mm wide and 1.25 mm deep, and fit it with outside pliers, size A2.
| Shaft Ø | 48 mm |
|---|---|
| Clip thickness | 1.75 mm |
| Groove Ø | 45.5 mm |
| Groove width | 1.85 mm |
| Groove depth | 1.25 mm |
| Pliers | outside, size A2 |
Sizes from DIN 471, as Benchsmith's Find → Circlip gives them. Groove depth = (shaft Ø − groove Ø) ÷ 2.
Open DIN 471-48 in BenchsmithAdd to order list
Bench note · why the groove, not the clip
The clip is named by the shaft it fits (Ø48), but you cut the groove: Ø45.5, 1.85 wide, 1.25 deep. Square corners at the bottom so the clip sits flat against the side.
Bench note · why outside pliers
A shaft clip (DIN 471) is opened to go on: outside pliers. Open it only as far as it takes to pass the shaft; stretched too far it stays loose in the groove.
One size up or down
- DIN 471-45shaft Ø45 (down)
- DIN 471-50shaft Ø50 (up)
Clip gone and only the groove left? Measure the shaft, or the bottom of the old groove, and type it into Benchsmith → Find → Circlip.