DIN 471 circlip, 22 mm shaft
Circlips › DIN 471-22
A DIN 471-22 is an external circlip (a shaft clip) for a 22 mm shaft, 1.2 mm thick. Cut the groove Ø21 mm, 1.3 mm wide and 0.5 mm deep, and fit it with outside pliers, size A1.
| Shaft Ø | 22 mm |
|---|---|
| Clip thickness | 1.2 mm |
| Groove Ø | 21 mm |
| Groove width | 1.3 mm |
| Groove depth | 0.5 mm |
| Pliers | outside, size A1 |
Sizes from DIN 471, as Benchsmith's Find → Circlip gives them. Groove depth = (shaft Ø − groove Ø) ÷ 2.
Open DIN 471-22 in BenchsmithAdd to order list
Bench note · why the groove, not the clip
The clip is named by the shaft it fits (Ø22), but you cut the groove: Ø21, 1.3 wide, 0.5 deep. Square corners at the bottom so the clip sits flat against the side.
Bench note · why outside pliers
A shaft clip (DIN 471) is opened to go on: outside pliers. Open it only as far as it takes to pass the shaft; stretched too far it stays loose in the groove.
Same Ø, bore clip
- DIN 472-22bore Ø22, groove Ø23
One size up or down
- DIN 471-21shaft Ø21 (down)
- DIN 471-24shaft Ø24 (up)
Clip gone and only the groove left? Measure the shaft, or the bottom of the old groove, and type it into Benchsmith → Find → Circlip.